FN Browning 1906

Pistols of all descriptions.
Post Reply
rlreyes1
Posts: 6
Joined: Thu Aug 23, 2018 11:58 pm
Location: Saint Petersburg

FN Browning 1906

Post by rlreyes1 »

I've got an FN Browning vest pocket (25acp) it had some missing parts. Ibhave since acquired everything that was missing and re-assembled, but the firing pin/striker will not catch on the sear when you rack the slide.
Does anyone have an idea on how to fix this?

This gun is the same as the Colt 1908.

Thanks ahead of time.

~Ray
Cap't N Coke PLZ!!! 8-)
User avatar
photohause
Posts: 1186
Joined: Thu Jul 19, 2018 5:11 pm

Post by photohause »

Drop a note to the NRA Technical Editor...you might be surprised. If no luck there, note to the NRA Museum curators, super nice & knowledgeable people.
“You didn’t finish school, did you?
User avatar
Villafuego
Posts: 122
Joined: Wed Jul 18, 2018 4:04 pm
Location: Land O' Lakes

Post by Villafuego »

Aside from ensuring the sear and striker contact surfaces are in good condition, you'll want to make sure that the striker spring isn't too long, and that it correctly fits inside the striker and around the guide when compressed....

with the striker forward, does the firing pin protrude thru the bolt face?

remove the recoil spring, then operate the slide manually.....does it retract far enough for the sear to engage the striker? If not, you may have an overly long / incorrect recoil spring

What parts did you replace?
Post Reply