Due to spammers, the registration have been temporarily disabled. I will reopen them as soon as possible. In the meantime, if you want to create an account, please contact me.

mauser repair tool question

Bolt guns, gas guns and long range shooting tactics.
Post Reply
Ben V.
Posts: 50
Joined: Sun Sep 02, 2018 12:36 pm
Location: Citrus County

mauser repair tool question

Post by Ben V. » Sat Sep 08, 2018 4:06 pm

I have a mauser yugo m48 that seems to have either a burr or mashed metallic piece of debris in the rear of the rear recoil lug channel of the receiver that is causing my bolt to stick after firing. i cant get in there with standard dremel bits (shafts are too short) I have looked at tooling at the big stores, and im at a loss of what to use. should i get a broaching bit? whatever i do, if i overdo it, is going to affect the accuracy of the gun, but i cant hammer the bolt open after every other shot, either.

it needs to be a 4-5" or longer hooked tool that i use to remove or more likely grind down this anomaly. any thoughts would be appreciated, cause im drawing a blank here, folks....

mgunner
Posts: 11
Joined: Thu Jul 19, 2018 12:28 pm
Location: fort lauderdale

Post by mgunner » Sat Sep 08, 2018 7:30 pm

a picture would help

Post Reply