Post your pics of pistols

[LastRites]

Nice Browning, if it were mine I'd be looking at some thin grips and take a drop of gun blue to the trigger pin to darken it up from when someone likely removed the mag disconnect.

[handlebar]

my 2 most recent acquisitions:

Italian surplus Beretta 92S in like new condition


EAA CZ clone (SAR B6P compact)

[DaveM]

Nice Browning, if it were mine I'd be looking at some thin grips and take a drop of gun blue to the trigger pin to darken it up from when someone likely removed the mag disconnect.

The pin has been touched up. I really don't know what he was trying to do. It's the wrong pin to remove the mag safety. The pin to do that is on the trigger itself.

[LastRites]

Nice Browning, if it were mine I'd be looking at some thin grips and take a drop of gun blue to the trigger pin to darken it up from when someone likely removed the mag disconnect.

The pin has been touched up. I really don't know what he was trying to do. It's the wrong pin to remove the mag safety. The pin to do that is on the trigger itself.

On older models you usually can remove the pin in the trigger and get the MG out, on newer models you have to yank the entire trigger out to remove it, and then replace the 3 coil trigger spring with the slightly stronger 2 coil trigger spring for better reset.

[drshame]

Sig German X5-L1, Shoots well up to its' reputation.

Prices thru the ceiling now since they can't be exported to the U-S anymore. Sig may eventually make them here. But I suspect it'll take a while for them to come close to their original German Craftsmanship.

[NorincoKid]

[captain steinbrenner]

What is that thing?

[NorincoKid]

What is that thing?

MP5K RAS/PDW in 9mm

[Gregh181]

Simply gorgeous

[NorincoKid]

Thanks

Actually just went up to Hernando Sportmans Club for the first time, checked it out, and test fired it. Couple hiccups, but I think it will be good to go. Still have to get the tube hanger welded and a few other things finished up (paint, get a cheap red-dot), but it looks like it will be fun..

Now to finish up its 16" carbine big brother

[Cardboard_killer]

It's CZ time!

CZ 75 (pre-B), chrome plate. Even prettier in person, and I just ordered thin blue aluminum grips from Cajun Works for it.

[Cardboard_killer]

Put some Cajun Gun Works aluminum thin grips on it.

[GLoCKeYeD]